linux-aspeed: Move to v5.4
This moves the OpenBMC kernel to a Linux v5.4 base.
There are 161 patches in dev-5.4. Of these 69 are backported from
upstream, leaving 92 out of tree patches.
Alexander Amelkin (1):
mtd: spi-nor: fix options for mx66l51235f
Andrew Jeffery (12):
dt-bindings: hwmon: pmbus: Add Maxim MAX31785 documentation
pmbus (max31785): Add support for devicetree configuration
pmbus (core): One-shot retries for failure to set page
pmbus (core): Use driver callbacks in pmbus_get_fan_rate()
pmbus (max31785): Wrap all I2C accessors in one-shot failure handlers
soc: aspeed: Miscellaneous control interfaces
ARM: dts: aspeed: witherspoon: Update max31785 node
ARM: dts: aspeed-g5: Expose VGA and SuperIO scratch registers
net: ftgmac100: Ungate RCLK for RMII on ASPEED MACs
pinctrl: aspeed-g6: Fix LPC/eSPI mux configuration
pinctrl: aspeed: Improve debug output
soc: aspeed: Fail probe of lpc-ctrl if reserved memory is not aligned
Arnd Bergmann (1):
ARM: aspeed: ast2500 is ARMv6K
Brad Bishop (4):
ARM: dts: aspeed-g6: Expose SuperIO scratch registers
soc: aspeed: lpc: Add G6 compatible strings
ipmi: aspeed-g6: Add compatible strings
reset: simple: Add AST2600 compatibility string
Cédric Le Goater (21):
mtd: spi-nor: aspeed: use command mode for reads
mtd: spi-nor: aspeed: add support for SPI dual IO read mode
mtd: spi-nor: aspeed: link controller with the ahb clock
mtd: spi-nor: aspeed: optimize read mode
mtd: spi-nor: aspeed: limit the maximum SPI frequency
mtd: spi-nor: aspeed: introduce a aspeed_smc_default_read() helper
mtd: spi-nor: aspeed: clarify 4BYTE address mode mask
mtd: spi-nor: aspeed: use memcpy_fromio() to capture the optimization buffer
mtd: spi-nor: aspeed: add support for the 4B opcodes
mtd: spi-nor: Add support for w25q512jv
mtd: spi-nor: aspeed: Introduce a field for the AHB physical address
mtd: spi-nor: aspeed: Introduce segment operations
mtd: spi-nor: aspeed: add initial support for ast2600
mtd: spi-nor: aspeed: Check for disabled segments on the AST2600
mtd: spi-nor: aspeed: Introduce training operations per platform
mtd: spi-nor: aspeed: Introduce a HCLK mask for training
mtd: spi-nor: aspeed: check upper freq limit when doing training
mtd: spi-nor: aspeed: add support for AST2600 training
mtd: spi-nor: aspeed: fix training of multiple CS on the AST2600
mtd: spi-nor: aspeed: Disable zero size segments on the AST2600
/dev/mem: add a devmem kernel parameter to activate the device
Eddie James (5):
i2c: aspeed: Add AST2600 compatible
hwmon: (pmbus/ibm-cffps) Switch LEDs to blocking brightness call
hwmon: (pmbus/ibm-cffps) Fix LED blink behavior
hwmon: (pmbus/ibm-cffps) Add version detection capability
ARM: dts: aspeed: rainier: Switch PSUs to unknown version
Fran Hsu (4):
ARM: dts: nuvoton: Add NPCM730 common device tree
ARM: dts: nuvoton: Add Quanta GSJ BMC pinctrl
ARM: dts: nuvoton: Add Quanta GSJ BMC Device Tree.
ARM: dts: nuvoton: Add GPIOs and LEDs to GSJ device tree
George Hung (2):
dt-binding: edac: add NPCM ECC documentation
edac: npcm: Add Nuvoton NPCM7xx EDAC driver
Jae Hyun Yoo (13):
ARM: dts: aspeed: peci: Add PECI node
clk: ast2600: enable BCLK for PCI/PCIe bus always
dt-bindings: Add PECI subsystem document
Documentation: ioctl: Add ioctl numbers for PECI subsystem
peci: Add support for PECI bus driver core
dt-bindings: Add bindings document of Aspeed PECI adapter
ARM: dts: aspeed: Add PECI node
peci: Add Aspeed PECI adapter driver
dt-bindings: mfd: Add Intel PECI client bindings document
mfd: intel-peci-client: Add Intel PECI client driver
Documentation: hwmon: Add documents for PECI hwmon drivers
hwmon: Add PECI cputemp driver
hwmon: Add PECI dimmtemp driver
Joel Stanley (9):
ARM: dts: aspeed-g4: Expose SuperIO scratch registers
ARM: dts: aspeed: ast2600evb: Enable FSI master
usb: gadget: Quieten gadget config message
clocksource: fttmr010: Parametrise shutdown
clocksource: fttmr010: Set interrupt and shutdown
clocksource: fttmr010: Add support for ast2600
watchdog: aspeed: Fix clock behaviour for ast2600
ARM: config: aspeed: Update defconfigs
Revert "ARM: dts: aspeed: peci: Add PECI node"
Johnny Huang (6):
pinctrl: aspeed-g6: Add AST2600 I3C1 and I3C2 pinmux config
pinctrl: aspeed-g6: Add support for the AST2600 USB pinmux
pinctrl: aspeed: Add ASPEED_SB_PINCONF() helper
pinctrl: aspeed: Move aspeed_pin_config_map to separate source file
pinctrl: aspeed: Use masks to describe pinconf bitfields
pinctrl: aspeed-g6: Add AST2600 pinconf support
Tali Perry (2):
dt-bindings: i2c: npcm7xx: add NPCM I2C controller documentation
i2c: npcm: Add Nuvoton NPCM I2C controller driver
Tomer Maimon (12):
dt-binding: bmc: Add NPCM7xx LPC BPC documentation
misc: npcm7xx-lpc-bpc: add NPCM7xx BIOS post code driver
dt-binding: bmc: add npcm7xx pci mailbox document
misc: mbox: add npcm7xx pci mailbox driver
dt-binding: net: document NPCM7xx EMC DT bindings
net: npcm: add NPCM7xx Ethernet MAC controller
ARM: configs: add defconfig for Nuvoton NPCM7xx BMC
ARM: dts: npcm7xx: Update device tree
arm: dts: add NPCM7xx RunBMC Olympus Quanta device tree
dt-bindings: peci: add NPCM PECI documentation
ARM: dts: npcm7xx: Add PECI node
peci: npcm: add NPCM PECI driver
(From meta-aspeed rev: 6d863dd22836673ccd2a5d40778a3d5e4e03d7ea)
Change-Id: I8f43925375c26bc88f94eee13430fcb03252b8ca
Signed-off-by: Joel Stanley <joel@jms.id.au>
Signed-off-by: Brad Bishop <bradleyb@fuzziesquirrel.com>
diff --git a/meta-aspeed/recipes-kernel/linux/linux-aspeed/aspeed-g4/defconfig b/meta-aspeed/recipes-kernel/linux/linux-aspeed/aspeed-g4/defconfig
index d0abbf1..939a60e 100644
--- a/meta-aspeed/recipes-kernel/linux/linux-aspeed/aspeed-g4/defconfig
+++ b/meta-aspeed/recipes-kernel/linux/linux-aspeed/aspeed-g4/defconfig
@@ -141,6 +141,7 @@
CONFIG_I2C_MUX_PCA954x=y
CONFIG_I2C_ASPEED=y
CONFIG_I2C_FSI=y
+CONFIG_SPI=y
CONFIG_GPIOLIB=y
CONFIG_GPIO_SYSFS=y
CONFIG_GPIO_ASPEED=y