linux-aspeed: Move to v5.3
This moves the OpenBMC kernel to a Linux v5.3 base.
There are 120 patches in dev-5.3. Of these, 56 are backported from
upstream, leaving 64 out of tree patches.
Alexander Amelkin (1):
mtd: spi-nor: fix options for mx66l51235f
Andrew Jeffery (26):
ARM: dts: aspeed: Describe SD controllers
ARM: dts: aspeed: Enable first MMC slot on AST2500 EVB
ARM: dts: aspeed: Add AST2600 pinmux nodes
net: phy: Add mdio-aspeed
net: ftgmac100: Add support for DT phy-handle property
net: ftgmac100: Select ASPEED MDIO driver for the AST2600
pinctrl: aspeed: Rename pin declaration macros
pinctrl: aspeed: Add PIN_DECL_3() helper
pinctrl: aspeed: Add multiple pin group support for functions
pinctrl: aspeed: Add SIG_DESC_CLEAR() helper
pinctrl: aspeed: Add AST2600 pinmux support
pinctrl: aspeed: Document existence of deprecated compatibles
mmc: sdhci-of-aspeed: Add support for the ASPEED SD controller
mmc: sdhci-of-aspeed: Drop redundant assignment to host->clock
mmc: sdhci-of-aspeed: Uphold clocks-on post-condition of set_clock()
mmc: sdhci-of-aspeed: Allow max-frequency limitation of SDCLK
mmc: sdhci-of-aspeed: Depend on CONFIG_OF_ADDRESS
dt-bindings: hwmon: pmbus: Add Maxim MAX31785 documentation
pmbus (max31785): Add support for devicetree configuration
pmbus (core): One-shot retries for failure to set page
pmbus (core): Use driver callbacks in pmbus_get_fan_rate()
pmbus (max31785): Wrap all I2C accessors in one-shot failure handlers
soc: aspeed: Miscellaneous control interfaces
ARM: dts: aspeed: witherspoon: Update max31785 node
ARM: dts: aspeed-g5: Expose VGA and SuperIO scratch registers
ARM: dts: ast2600-evb: eMMC configuration
Andrew Peng (1):
ARM: dts: aspeed: Add Lenovo Hr855xg2 BMC
Ben Pai (1):
ARM: dts: aspeed: Add Mihawk BMC platform
Cédric Le Goater (11):
mtd: spi-nor: aspeed: use command mode for reads
mtd: spi-nor: aspeed: add support for SPI dual IO read mode
mtd: spi-nor: aspeed: link controller with the ahb clock
mtd: spi-nor: aspeed: optimize read mode
mtd: spi-nor: aspeed: limit the maximum SPI frequency
/dev/mem: add a devmem kernel parameter to activate the device
ARM: dts: aspeed: Add "spi-max-frequency" property
mtd: spi-nor: aspeed: introduce a aspeed_smc_default_read() helper
mtd: spi-nor: aspeed: clarify 4BYTE address mode mask
mtd: spi-nor: aspeed: use memcpy_fromio() to capture the optimization buffer
mtd: spi-nor: aspeed: add support for the 4B opcodes
David S. Miller (1):
ftgmac100: Fix build.
Eddie James (4):
ARM: dts: aspeed: swift: Change power supplies to version 2
pmbus: (ibm-cffps) Add support for version 2 of the PSU
i2c: aspeed: Add AST2600 compatible
ARM: dts: aspeed: tacoma: Enable I2C busses
Fran Hsu (4):
ARM: dts: nuvoton: Add NPCM730 common device tree
ARM: dts: nuvoton: Add Quanta GSJ BMC pinctrl
ARM: dts: nuvoton: Add Quanta GSJ BMC Device Tree.
ARM: dts: nuvoton: Add GPIOs and LEDs to GSJ device tree
George Hung (2):
dt-binding: edac: add NPCM ECC documentation
edac: npcm: Add Nuvoton NPCM7xx EDAC driver
Hongwei Zhang (1):
ARM: dts: aspeed: Add SGPM pinmux
Ivan Mikhaylov (2):
ARM: dts: aspeed: vesnin: Add wdt2 with alt-boot option
ARM: dts: aspeed: vesnin: Add secondary SPI flash chip
Jae Hyun Yoo (11):
dt-bindings: Add a document of PECI subsystem
peci: Add support for PECI bus driver core
dt-bindings: Add a document of PECI adapter driver for ASPEED AST24xx/25xx SoCs
peci: Add a PECI adapter driver for Aspeed AST24xx/AST25xx
dt-bindings: mfd: Add a document for PECI client MFD
mfd: intel-peci-client: Add PECI client MFD driver
Documentation: hwmon: Add documents for PECI hwmon client drivers
hwmon: Add PECI cputemp driver
hwmon: Add PECI dimmtemp driver
Add maintainers for the PECI subsystem
ARM: dts: aspeed: peci: Add PECI node
Joel Stanley (19):
ARM: aspeed: Select timer in each SoC
ARM: aspeed: Add ASPEED AST2600 architecture
ARM: aspeed: Enable SMP boot
ARM: configs: aspeed: Refresh defconfigs
ARM: configs: aspeed_g5: Enable AST2600
ARM: dts: aspeed: swift: Add eMMC device
ARM: dts: aspeed-g4: Add all flash chips
ARM; dts: aspeed: mihawk: File should not be executable
clk: aspeed: Add SDIO gate
clk: aspeed: Move structures to header
clk: Add support for AST2600 SoC
ARM: dts: aspeed: Add AST2600 and EVB
ARM: dts: aspeed-g4: Expose SuperIO scratch registers
fsi: Add ast2600 master driver
ARM: dts: aspeed-g6: Describe FSI masters
ARM: dts: aspeed: ast2600evb: Enable FSI master
ARM: dts: aspeed: Add Tacoma machine
ARM: config: aspeed: Update defconfigs
ARM: dts: aspeed-g6: Add i2c buses
John Wang (1):
ARM: dts: aspeed: fp5280g2: Fix power supply address
Linus Walleij (3):
gpio: aspeed: Pass irqchip when adding gpiochip
gpio: tqmx86: Pass irqchip when adding gpiochip
gpio: Initialize the irqchip valid_mask with a callback
Matt Spinler (1):
ARM: dts: aspeed: swift: Fix FSI GPIOs
Nathan Chancellor (1):
pinctrl: aspeed: g6: Remove const specifier from aspeed_g6_sig_expr_set's ctx parameter
Oscar A Perez (1):
ARM: dts: aspeed-g5: Fixe gpio-ranges upper limit
Rashmica Gupta (5):
gpio/aspeed: Fix incorrect number of banks
gpio: aspeed: Setup irqchip dynamically
gpio: aspeed: Use ngpio property from device tree if available
gpio: aspeed: Add in ast2600 details to Aspeed driver
ARM: dts: aspeed-g6: Add gpio devices
Ryan Chen (1):
watchdog: aspeed: Add support for AST2600
Tao Ren (3):
ARM: dts: aspeed: Add Facebook Minipack BMC
ARM: dts: aspeed: Add Facebook Wedge40 BMC
ARM: dts: aspeed: Add Facebook Wedge100 BMC
Tomer Maimon (15):
dt-binding: spi: add NPCM FIU controller
spi: npcm-fiu: add NPCM FIU controller driver
clk: nuvoton: add npcm750 clock function prototype initialization
dt-bindings: i2c: npcm7xx: add binding for i2c controller
i2c: npcm: driver for Poleg i2c controller
dt-binding: bmc: Add NPCM7xx LPC BPC documentation
misc: npcm7xx-lpc-bpc: add NPCM7xx BIOS post code driver
dt-binding: bmc: add npcm7xx pci mailbox document
misc: mbox: add npcm7xx pci mailbox driver
dt-binding: net: document NPCM7xx EMC DT bindings
net: npcm: add NPCM7xx Ethernet MAC controller
dt-binding: peci: add NPCM PECI documentation
peci: npcm: add NPCM PECI driver
ARM: configs: add defconfig for Nuvoton NPCM7xx BMC
ARM: dts: npcm7xx: Update device tree
Vijay Khemka (3):
ARM: dts: aspeed: tiogapass: Add VR devices
ARM: dts: aspeed: tiogapass: Move battery sensor
ARM: dts: aspeed: tiogapass: Add Riser card
Wei Yongjun (1):
mmc: sdhci-of-aspeed: Fix return value check in aspeed_sdc_probe()
William A. Kennington III (1):
ARM: configs: aspeed: Enable commonly used network functionality
Change-Id: I3979be25325d60c7ff76673c911f72ee2bfaaddc
Signed-off-by: Joel Stanley <joel@jms.id.au>
1 file changed