tree 2d2c33aad65b3e49aae7a51be736894f0b460407
parent 53e322518fe6f471663746934e38bf5d8143a501
author Joel Stanley <joel@jms.id.au> 1574902864 +1030
committer Joel Stanley <joel@jms.id.au> 1576646646 +1100

linux-aspeed: Move to v5.4

This moves the OpenBMC kernel to a Linux v5.4 base.

There are 161 patches in dev-5.4. Of these 69 are backported from
upstream, leaving 92 out of tree patches.

Alexander Amelkin (1):
      mtd: spi-nor: fix options for mx66l51235f

Andrew Jeffery (12):
      dt-bindings: hwmon: pmbus: Add Maxim MAX31785 documentation
      pmbus (max31785): Add support for devicetree configuration
      pmbus (core): One-shot retries for failure to set page
      pmbus (core): Use driver callbacks in pmbus_get_fan_rate()
      pmbus (max31785): Wrap all I2C accessors in one-shot failure handlers
      soc: aspeed: Miscellaneous control interfaces
      ARM: dts: aspeed: witherspoon: Update max31785 node
      ARM: dts: aspeed-g5: Expose VGA and SuperIO scratch registers
      net: ftgmac100: Ungate RCLK for RMII on ASPEED MACs
      pinctrl: aspeed-g6: Fix LPC/eSPI mux configuration
      pinctrl: aspeed: Improve debug output
      soc: aspeed: Fail probe of lpc-ctrl if reserved memory is not aligned

Arnd Bergmann (1):
      ARM: aspeed: ast2500 is ARMv6K

Brad Bishop (4):
      ARM: dts: aspeed-g6: Expose SuperIO scratch registers
      soc: aspeed: lpc: Add G6 compatible strings
      ipmi: aspeed-g6: Add compatible strings
      reset: simple: Add AST2600 compatibility string

Cédric Le Goater (21):
      mtd: spi-nor: aspeed: use command mode for reads
      mtd: spi-nor: aspeed: add support for SPI dual IO read mode
      mtd: spi-nor: aspeed: link controller with the ahb clock
      mtd: spi-nor: aspeed: optimize read mode
      mtd: spi-nor: aspeed: limit the maximum SPI frequency
      mtd: spi-nor: aspeed: introduce a aspeed_smc_default_read() helper
      mtd: spi-nor: aspeed: clarify 4BYTE address mode mask
      mtd: spi-nor: aspeed: use memcpy_fromio() to capture the optimization buffer
      mtd: spi-nor: aspeed: add support for the 4B opcodes
      mtd: spi-nor: Add support for w25q512jv
      mtd: spi-nor: aspeed: Introduce a field for the AHB physical address
      mtd: spi-nor: aspeed: Introduce segment operations
      mtd: spi-nor: aspeed: add initial support for ast2600
      mtd: spi-nor: aspeed: Check for disabled segments on the AST2600
      mtd: spi-nor: aspeed: Introduce training operations per platform
      mtd: spi-nor: aspeed: Introduce a HCLK mask for training
      mtd: spi-nor: aspeed: check upper freq limit when doing training
      mtd: spi-nor: aspeed: add support for AST2600 training
      mtd: spi-nor: aspeed: fix training of multiple CS on the AST2600
      mtd: spi-nor: aspeed: Disable zero size segments on the AST2600
      /dev/mem: add a devmem kernel parameter to activate the device

Eddie James (5):
      i2c: aspeed: Add AST2600 compatible
      hwmon: (pmbus/ibm-cffps) Switch LEDs to blocking brightness call
      hwmon: (pmbus/ibm-cffps) Fix LED blink behavior
      hwmon: (pmbus/ibm-cffps) Add version detection capability
      ARM: dts: aspeed: rainier: Switch PSUs to unknown version

Fran Hsu (4):
      ARM: dts: nuvoton: Add NPCM730 common device tree
      ARM: dts: nuvoton: Add Quanta GSJ BMC pinctrl
      ARM: dts: nuvoton: Add Quanta GSJ BMC Device Tree.
      ARM: dts: nuvoton: Add GPIOs and LEDs to GSJ device tree

George Hung (2):
      dt-binding: edac: add NPCM ECC documentation
      edac: npcm: Add Nuvoton NPCM7xx EDAC driver

Jae Hyun Yoo (13):
      ARM: dts: aspeed: peci: Add PECI node
      clk: ast2600: enable BCLK for PCI/PCIe bus always
      dt-bindings: Add PECI subsystem document
      Documentation: ioctl: Add ioctl numbers for PECI subsystem
      peci: Add support for PECI bus driver core
      dt-bindings: Add bindings document of Aspeed PECI adapter
      ARM: dts: aspeed: Add PECI node
      peci: Add Aspeed PECI adapter driver
      dt-bindings: mfd: Add Intel PECI client bindings document
      mfd: intel-peci-client: Add Intel PECI client driver
      Documentation: hwmon: Add documents for PECI hwmon drivers
      hwmon: Add PECI cputemp driver
      hwmon: Add PECI dimmtemp driver

Joel Stanley (9):
      ARM: dts: aspeed-g4: Expose SuperIO scratch registers
      ARM: dts: aspeed: ast2600evb: Enable FSI master
      usb: gadget: Quieten gadget config message
      clocksource: fttmr010: Parametrise shutdown
      clocksource: fttmr010: Set interrupt and shutdown
      clocksource: fttmr010: Add support for ast2600
      watchdog: aspeed: Fix clock behaviour for ast2600
      ARM: config: aspeed: Update defconfigs
      Revert "ARM: dts: aspeed: peci: Add PECI node"

Johnny Huang (6):
      pinctrl: aspeed-g6: Add AST2600 I3C1 and I3C2 pinmux config
      pinctrl: aspeed-g6: Add support for the AST2600 USB pinmux
      pinctrl: aspeed: Add ASPEED_SB_PINCONF() helper
      pinctrl: aspeed: Move aspeed_pin_config_map to separate source file
      pinctrl: aspeed: Use masks to describe pinconf bitfields
      pinctrl: aspeed-g6: Add AST2600 pinconf support

Tali Perry (2):
      dt-bindings: i2c: npcm7xx: add NPCM I2C controller documentation
      i2c: npcm: Add Nuvoton NPCM I2C controller driver

Tomer Maimon (12):
      dt-binding: bmc: Add NPCM7xx LPC BPC documentation
      misc: npcm7xx-lpc-bpc: add NPCM7xx BIOS post code driver
      dt-binding: bmc: add npcm7xx pci mailbox document
      misc: mbox: add npcm7xx pci mailbox driver
      dt-binding: net: document NPCM7xx EMC DT bindings
      net: npcm: add NPCM7xx Ethernet MAC controller
      ARM: configs: add defconfig for Nuvoton NPCM7xx BMC
      ARM: dts: npcm7xx: Update device tree
      arm: dts: add NPCM7xx RunBMC Olympus Quanta device tree
      dt-bindings: peci: add NPCM PECI documentation
      ARM: dts: npcm7xx: Add PECI node
      peci: npcm: add NPCM PECI driver

Change-Id: Ica5bc63e59a60ee0669463ab84bfd0d74627ce45
Signed-off-by: Joel Stanley <joel@jms.id.au>