tree 20fe5639a3e35fc8da08a5a00e113afaa218b5e6
parent ff2e4ed2f8f642fe54ac094c02c22166d8ee3131
author Joel Stanley <joel@jms.id.au> 1543811690 +1030
committer Joel Stanley <joel@jms.id.au> 1543874179 +0000

linux-aspeed: Move to 4.19

The OpenBMC ASPEED kernel continues in it's quest to track upstream.
This tree is a rebase of the dev-4.18 tree on top of 4.19 witht 58 out
of tree patches.

Currently the base is 4.19.6, the latest 4.19 stable release.

The out of tree patches are as follows. Note that some of these have
landed in 4.20 or are queued for 4.21.

Adriana Kobylak (1):
      ARM: config: aspeed: Add Network Block Device

Alexander Amelkin (1):
      mtd: spi-nor: fix options for mx66l51235f

Andrew Jeffery (8):
      ARM: dts: aspeed: witherspoon: Update max31785 node
      dt-bindings: hwmon: pmbus: Add Maxim MAX31785 documentation
      pmbus (max31785): Add support for devicetree configuration
      pmbus (core): One-shot retries for failure to set page
      pmbus (core): Use driver callbacks in pmbus_get_fan_rate()
      pmbus (max31785): Wrap all I2C accessors in one-shot failure handlers
      soc: aspeed: Miscellaneous control interfaces
      ARM: dts: aspeed-g5: Expose VGA and SuperIO scratch registers

Benjamin Herrenschmidt (4):
      ARM: dts: aspeed: Romulus system can use coprocessor for FSI
      ARM: dts: aspeed: Palmetto system can use coprocessor for FSI
      ARM: dts: aspeed: Add Power8 CFAM description for use by Palmetto
      ARM: dts: aspeed: Add Power9 CFAM description

Brad Bishop (1):
      ARM: configs: Remove atags from Aspeed G4 config

Brendan Higgins (1):
      i2c: aspeed: fix invalid clock parameters for very large divisors

Christopher Bostic (1):
      iio: dps310: Temperature measurement errata

Cyril Bur (1):
      misc: Add ASPEED mbox driver

Cédric Le Goater (7):
      mtd: spi-nor: aspeed: use command mode for reads
      mtd: spi-nor: aspeed: add support for SPI dual IO read mode
      mtd: spi-nor: aspeed: link controller with the ahb clock
      mtd: spi-nor: aspeed: optimize read mode
      mtd: spi-nor: aspeed: limit the maximum SPI frequency
      ARM: dts: aspeed: Add "spi-max-frequency" property
      /dev/mem: add a devmem kernel parameter to activate the device

Eddie James (1):
      fsi: sbefifo: Add missing mutex_unlock

Edward A. James (2):
      drivers/fsi: Add On-Chip Controller (OCC) driver
      hwmon: Add On-Chip Controller (OCC) hwmon driver

Guenter Roeck (1):
      i2c: aspeed: Acknowledge most interrupts early in interrupt handler

Jae Hyun Yoo (1):
      i2c: aspeed: Handle master/slave combined irq events properly

Joel Stanley (19):
      ARM: dts: aspeed-palmetto: Add LPC control node
      ARM: dts: aspeed-palmetto: Add i2c OCC hwmon node
      ARM: dts: aspeed-ast2500: Update flash layout
      ARM: dts: aspeed: Add LPC mailbox node
      ARM: dts: aspeed: Enable mbox
      iio: Add driver for Infineon DPS310
      ARM: dts: aspeed-g4: Expose SuperIO scratch registers
      ARM: dts: aspeed-g5: Add resets and clocks to GFX node
      ARM: dts: aspeed: Enable the GFX IP
      ARM: dts: aspeed: Enable VHUB on Romulus
      drm: Add ASPEED GFX driver
      drm: aspeed: Debugfs interface for GFX registers
      dt-bindings: gpu: Add ASPEED GFX bindings document
      ARM: config: aspeed: Add out of tree drivers
      ARM: dts: Add OCC description to Power9 dtsi
      rtc: Add ASPEED RTC driver
      dt-bindings: rtc: Add ASPEED description
      ARM: aspeed: Add RTC node
      ARM: config: aspeed: Add internal RTC driver

Justin.Lee1@Dell.com (1):
      net/ncsi: Extend NC-SI Netlink interface to allow user space to send NC-SI command

Lei YU (1):
      ARM: dts: aspeed: romulus: Enable iio-hwmon-battery

Matt Spinler (1):
      ARM: dts: aspeed: wspoon: Enable iio-hwmon battery

Tomer Maimon (2):
      dt-binding: pinctrl: Add NPCM7xx pinctrl and GPIO documentation
      pinctrl: nuvoton: add NPCM7xx pinctrl and GPIO driver

Vijay Khemka (2):
      net/ncsi: Add NCSI OEM command support
      net/ncsi: Add NCSI Broadcom OEM command

Wolfram Sang (1):
      i2c: aspeed: use proper annotation for "fall through"

YueHaibing (1):
      net/ncsi: remove duplicated include from ncsi-netlink.c

Change-Id: Ia45aa6c3fcd7edb3face492f3ff4586fa2ff5418
Signed-off-by: Joel Stanley <joel@jms.id.au>