wspoon: Additional thermal modes
Add the additional thermal modes needed to handle adjusting the fan
floor speeds necessary to support some hot pci cards.
Change-Id: I58c9f39a3405b8b90d73aff80b5e59f0c97d9b2f
Signed-off-by: Matthew Barth <msbarth@us.ibm.com>
diff --git a/meta-witherspoon/recipes-phosphor/fans/phosphor-fan-control-zone-config/witherspoon/zones.yaml b/meta-witherspoon/recipes-phosphor/fans/phosphor-fan-control-zone-config/witherspoon/zones.yaml
index d31b304..63303d7 100644
--- a/meta-witherspoon/recipes-phosphor/fans/phosphor-fan-control-zone-config/witherspoon/zones.yaml
+++ b/meta-witherspoon/recipes-phosphor/fans/phosphor-fan-control-zone-config/witherspoon/zones.yaml
@@ -28,9 +28,19 @@
- value: CUSTOM
description: >
Custom thermal control mode for handling the use of
- optical cables located behind the GPU exhaust that
- could produce overtemp warnings without this mode
- enabled.
+ PCI cards located behind the GPU exhaust that
+ could overtemp where the default mode is not
+ sufficient enough.
+ - value: HEAVY_IO
+ description: >
+ Heavy IO thermal control mode for handling the use
+ of PCI cards that produce heavy IO utilization and
+ could overtemp.
+ - value: MAX_BASE_FAN_FLOOR
+ description: >
+ Maximum base fan floor mode is for handling the
+ use of any hardware that requires the highest
+ amount of cooling even when the system may be idle.
- name: Current
type: string
persist: true
@@ -63,11 +73,28 @@
- value: DEFAULT
description: >
Default thermal control mode
+ - value: CUSTOM
+ description: >
+ Custom thermal control mode for handling the use of
+ PCI cards located behind the GPU exhaust that
+ could overtemp where the default mode is not
+ sufficient enough.
+ - value: HEAVY_IO
+ description: >
+ Heavy IO thermal control mode for handling the use
+ of PCI cards that produce heavy IO utilization and
+ could overtemp.
+ - value: MAX_BASE_FAN_FLOOR
+ description: >
+ Maximum base fan floor mode is for handling the
+ use of any hardware that requires the highest
+ amount of cooling even when the system may be idle.
- name: Current
type: string
persist: true
values:
- - value: DEFAULT
- description: >
- Set current thermal control mode to the
- default. No other modes are supported.
+ - value: DEFAULT
+ description: >
+ Set current thermal control mode to the
+ default which will be replaced on startup if
+ another selected mode was persisted.