Added network testcase to configure multiple IPv4 addresses and verify
Change-Id: I7d4165a551e1e4e63f22572d39abea2becb725fe
Signed-off-by: Anves Kumar rayankula <anvesr77@in.ibm.com>
diff --git a/redfish/managers/test_bmc_network_conf.robot b/redfish/managers/test_bmc_network_conf.robot
index 6b38372..d8228f8 100644
--- a/redfish/managers/test_bmc_network_conf.robot
+++ b/redfish/managers/test_bmc_network_conf.robot
@@ -541,6 +541,41 @@
END
+Configure And Verify Multiple IPv4 Addresses
+ [Documentation] Configure multiple IPv4 addresses and verify.
+ [Tags] Configure_And_Verify_Multiple_IPv4_Addresse
+ [Teardown] Run Keywords
+ ... Delete IP Address ${test_ipv4_addr} AND Delete IP Address ${test_ipv4_addr2}
+ ... AND Test Teardown Execution
+
+ ${ip1}= Create dictionary Address=${test_ipv4_addr}
+ ... SubnetMask=255.255.0.0 Gateway=${test_gateway}
+ ${ip2}= Create dictionary Address=${test_ipv4_addr2}
+ ... SubnetMask=255.255.252.0 Gateway=${test_gateway}
+
+ ${empty_dict}= Create Dictionary
+ ${patch_list}= Create List
+ ${network_configurations}= Get Network Configuration
+ ${num_entries}= Get Length ${network_configurations}
+
+ FOR ${INDEX} IN RANGE 0 ${num_entries}
+ Append To List ${patch_list} ${empty_dict}
+ END
+
+ # We need not check for existence of IP on BMC while adding.
+ Append To List ${patch_list} ${ip1} ${ip2}
+ ${payload}= Create Dictionary IPv4StaticAddresses=${patch_list}
+ ${active_channel_config}= Get Active Channel Config
+ ${ethernet_interface}= Set Variable ${active_channel_config['${CHANNEL_NUMBER}']['name']}
+ Redfish.patch ${REDFISH_NW_ETH_IFACE}${ethernet_interface} body=&{payload}
+
+ # Note: Network restart takes around 15-18s after patch request processing.
+ Sleep ${NETWORK_TIMEOUT}s
+ Wait For Host To Ping ${OPENBMC_HOST} ${NETWORK_TIMEOUT}
+ Verify IP On BMC ${test_ipv4_addr}
+ Verify IP On BMC ${test_ipv4_addr2}
+
+
*** Keywords ***
Test Setup Execution