| #!/bin/sh -e |
| |
| # shellcheck disable=SC2039 |
| # shellcheck disable=SC2112 |
| # shellcheck disable=SC3010 |
| # shellcheck disable=SC3030 |
| # shellcheck disable=SC3054 |
| |
| export obmc_console_tty=("ttyS0" "ttyS1" "ttyS2" "ttyS3" "ttyS7" "ttyS8") |
| |
| function get_uart_port() |
| { |
| tty=$1 |
| case "${tty}" in |
| "ttyS0") uart=1 |
| ;; |
| "ttyS1") uart=2 |
| ;; |
| "ttyS2") uart=3 |
| ;; |
| "ttyS3") uart=4 |
| ;; |
| "ttyS7") uart=0 |
| ;; |
| "ttyS8") uart=0 |
| ;; |
| *) echo "Invalid tty passed to $0. Exiting!" |
| exit 1; |
| ;; |
| esac |
| echo $uart |
| } |
| |
| function uart_console_setup() |
| { |
| # Default the host routing through the mux to use the BMC (2) |
| # This allows the SoL console in webui, and the ssh port 2200, to work |
| # upon startup. If UART transcievers are installed on the header and required, |
| # this value should be set to 1 |
| for tty in "${obmc_console_tty[@]}"; do |
| uart=$(get_uart_port "$tty") |
| if [ "${uart}" -ne 0 ] |
| then |
| /usr/sbin/ampere_uartmux_ctrl.sh "${uart}" 2 |
| fi |
| done |
| } |