Change some properties name in SOL Dbus
Change some properties name in SOL dbus interface to make the meaning
of the properties more clearly.
Change-Id: I11dae890c23dee0462708ae467db95a56bb00061
Signed-off-by: Cheng C Yang <cheng.c.yang@linux.intel.com>
diff --git a/xyz/openbmc_project/Ipmi/SOL.interface.yaml b/xyz/openbmc_project/Ipmi/SOL.interface.yaml
index 94db59f..96c8c87 100644
--- a/xyz/openbmc_project/Ipmi/SOL.interface.yaml
+++ b/xyz/openbmc_project/Ipmi/SOL.interface.yaml
@@ -2,8 +2,8 @@
SOL properties use for Get/Set SOL config parameter command in host-ipmid
sending config to SOL process in net-ipmid.
Since some platforms need to access Get/Set SOL config parameter command
- through KCS, and current sol manager is implemented in net-ipmid and
- cannot be accessed by host-ipmid, add a dbus interface for host-ipmid
+ through KCS, and current SOL manager is implemented in net-ipmid and
+ cannot be accessed by host-ipmid, add a D-Bus interface for host-ipmid
command to transfer properties to net-ipmid.
This interface will be implemented in phosphor-settings.
properties:
@@ -17,12 +17,20 @@
description: >
SOL Enable property, this controls whether the SOL payload type
can be activated.
- - name: Authentication
+ - name: ForceEncryption
+ type: boolean
+ description: >
+ If SOL enable Force Payload Encryption.
+ - name: ForceAuthentication
+ type: boolean
+ description: >
+ If SOL enable Force Payload Authentication
+ - name: Privilege
type: byte
description: >
- If SOL enable Force Payload Encryption and Authenticaton.
- And the minimun operating privilege level SOL required.
- - name: Accumulate
+ Sets the minimum operating privilege level that is required to
+ be able to activate SOL by Activate Payload command.
+ - name: AccumulateIntervalMS
type: byte
description: >
Character Accumulate Interval in 5ms increments.
@@ -31,13 +39,14 @@
type: byte
description: >
BMC will automatically send an SOL character data packet containing
- this number of characters.
+ this number of characters as soon as this number of characters
+ (or greater) has been accepted from the baseboard serial controller.
- name: RetryCount
type: byte
description: >
Packet will be dropped if no ACK/NACK received by time retries
expire.
- - name: RetryInterval
+ - name: RetryIntervalMS
type: byte
description: >
Retry Interval in 10ms increments.