markdownlint: fix all warnings
Signed-off-by: Patrick Williams <patrick@stwcx.xyz>
Change-Id: I0b596901eaa0eb80edfba31007c7d106797127f0
diff --git a/docs/mrw-xml-requirements.md b/docs/mrw-xml-requirements.md
index 09514b9..37bd143 100644
--- a/docs/mrw-xml-requirements.md
+++ b/docs/mrw-xml-requirements.md
@@ -16,10 +16,10 @@
To specify a target in the MRW should be in the inventory:
-- Set the FRU_NAME attribute of that target.
+- Set the `FRU_NAME` attribute of that target.
**Note**: The BMC and cores will be automatically added without the need to set
-FRU_NAME.
+`FRU_NAME`.
## BMC Device Tree
@@ -37,11 +37,11 @@
### System Level Attributes
-##### SYSTEM_NAME
+#### `SYSTEM_NAME`
The name of the system as the firmware would know it.
-##### MANUFACTURER
+#### MANUFACTURER
The system manufacturer.
@@ -68,12 +68,12 @@
connected to an ethernet slave unit. Additionally, the following attributes may
need to be set.
-##### NCSI_MODE
+#### `NCSI_MODE`
This attribute in the ethernet master unit can be set to 1 if the link uses
NCSI. The default is 0.
-##### USE_HW_CHECKSUM
+#### `USE_HW_CHECKSUM`
This attribute in the ethernet master unit can be set to 1 if the MAC has
hardware checksum enabled, or 0 if not enabled. The default is 1.
@@ -90,7 +90,7 @@
their GPIO master endpoints. The instance name in the MRW is the name of its
node in the device tree.
-##### ON_STATE
+#### `ON_STATE`
Set to the logic value required to activate the LED - either 0 or 1. The default
is 0.
@@ -100,18 +100,18 @@
I2C devices are enabled by connecting the I2C master units in the BMC to the I2C
slave units on the devices.
-##### I2C_ADDRESS
+#### `I2C_ADDRESS`
The 8 bit hexadecimal I2C address should be set in the slave unit of the end
device.
-##### BMC_DT_COMPATIBLE
+#### `BMC_DT_COMPATIBLE`
When creating a new XML device model, this attribute should be used to specify
which device driver the kernel will use to access the device. For example,
`ti,423` or `bosch,bmp280`. For existing parts, this should already be set.
-##### BMC_DT_ATTR_NAMES
+#### `BMC_DT_ATTR_NAMES`
This attribute is also only required when creating a new XML representation of
an I2C device. It specifies which other attributes of the device should be