tree d82c5308bb2d4042741ef40a134d9cc4adcc8e72
parent b0475e7a5688fd9ab5c670adc630ad53d7de8607
author Shawn McCarney <shawnmm@us.ibm.com> 1690928707 -0500
committer Shawn McCarney <shawnmm@us.ibm.com> 1692645448 +0000

pseq: Create Bonnell configuration file

Create the power sequencer configuration file for Bonnell systems.  This
file identifies the PMBus rails and the GPIO lines/pins that should be
checked when a pgood failure occurs.

On Bonnell systems no GPIO lines need to be checked.

Tested:
* Configuration file loading
  * Verified file is found on Bonnell systems using D-Bus property
  * Verified file is loaded successfully without errors
  * Verified all rails in file are stored in C++ data structures
  * Verified having empty pin array does not cause an error
  * Tested where file contains a syntax error
    * Verified error message is written to journal
    * Verified no error log created
* pgood detection
  * Verified system powers on cleanly when no pgood error is present
    * chassison
      * Verified chassis is powered on
      * Verified no error logs created
      * Verified no error messages written to the journal
    * poweron
      * Verified system is powered on
      * Verified no error logs created
      * Verified no error messages written to the journal
  * Verified system powers off cleanly when no pgood error is present
    * chassisoff
      * Verified chassis is powered off
      * Verified no error logs created
      * Verified no error messages written to the journal
    * poweroff
      * Verified system is powered off
      * Verified no error logs created
      * Verified no error messages written to the journal
  * Test where a pgood error is detected in a rail
    * Verified pgood failure is detected
    * Verified error message written to the journal
    * Verified GPIO values written to the journal
    * Verified error log is created
    * Tested with a pgood error on each rail in the config file
  * Test where pgood failure occurs during power on attempt
  * Test where pgood failure occurs after system was successfully
    powered on

Change-Id: I431d2dd7e99f2a99bbab936d6fad03af5654886f
Signed-off-by: Shawn McCarney <shawnmm@us.ibm.com>