tree: 9e9d2c3ac9e68d889d065290533e8a8ca8b59098 [path history] [tgz]
  1. config_file_parser.cpp
  2. config_file_parser.hpp
  3. config_file_parser_error.hpp
  4. meson.build
  5. power_control.cpp
  6. power_control.hpp
  7. power_control_main.cpp
  8. power_interface.cpp
  9. power_interface.hpp
  10. power_sequencer_device.hpp
  11. power_sequencer_monitor.cpp
  12. power_sequencer_monitor.hpp
  13. rail.hpp
  14. README.md
  15. services.cpp
  16. services.hpp
  17. ucd90160_monitor.cpp
  18. ucd90160_monitor.hpp
  19. ucd90320_monitor.cpp
  20. ucd90320_monitor.hpp
  21. ucd90x_monitor.cpp
  22. ucd90x_monitor.hpp
phosphor-power-sequencer/src/README.md

Overview

This directory contains the source code for applications performing system power on and off control, and power sequencer device configuration and monitoring.

Class Descriptions

PowerControl

Implements GPIO control of power on / off and monitoring of the chassis power good (pgood). The GPIOs are defined in the device tree and are named power-chassis-control and power-chassis-good respectively. The chassis pgood is monitored on a three second poll. Enforces a minimum power off time of 15 seconds from cold start and 25 seconds from power off.

Provides the server implementation of the org.openbmc.control.Power D-Bus interface.

Determines the type and I2C information of the power sequencer device with the Entity Manager xyz.openbmc_project.Configuration.UCD90320 or xyz.openbmc_project.Configuration.UCD90160 interface. If a specific device interface is not provided or not desired, a generic base class implementation (see the PowerSequencerMonitor class below) will be used.

PowerInterface

Defines the org.openbmc.control.Power D-Bus interface.

The state property is set to initiate a power on or power off sequence. The power good pgood property reflects the power state of the chassis. At power on time the pgood will lag the state as the power sequencer performs its processing. The same lag will occur on a requested power off. Loss of pgood without a state change request indicates a pgood failure.

PowerSequencerMonitor

Implements a generic power sequencer device monitoring interface. Used when the specific device type is not specified or cannot be determined. Also used as a base class for specific device classes. The generic implementation does not do any device specific analysis and does not need Entity Manager or JSON file configuration.

UCD90xMonitor

Defines a base class for monitoring the UCD90* family of power sequencer devices and implements the common behavior. Uses the Entity Manager IBMCompatibleSystem interface to locate its JSON based configuration. The loaded configuration allows pgood failure analysis to determine the specific voltage rail or pgood pin which has failed.

UCD90320Monitor

Implements a specific UCD90320 power sequencer device monitoring class.

UCD90160Monitor

Implements a specific UCD90160 power sequencer device monitoring class.