meta-ampere: enable Host check GPIO interface
Enable host-gpios option in phosphor-state-manager to support Host state
checking when BMC reboots. Also updateampere_host_check.sh to check Host
State via GPIO interface
Tested:
1. Define host0-ready into device tree.
2. Power On the Host. Reboot BMC, then check if CurrentHostState shows
Running.
3. Power OFF the Host. Reboot BMC, then check if CurrentHostState shows
Off.
Signed-off-by: Thang Q. Nguyen <thang@os.amperecomputing.com>
Signed-off-by: Thang Tran <thuutran@amperecomputing.com>
Change-Id: I0331dfa340eb5bba201475ab9cada42e0946c8f8
diff --git a/meta-ampere/meta-common/recipes-phosphor/host/ampere-hostctrl/ampere-host-on-host-check@.service b/meta-ampere/meta-common/recipes-phosphor/host/ampere-hostctrl/ampere-host-on-host-check@.service
new file mode 100644
index 0000000..7698052
--- /dev/null
+++ b/meta-ampere/meta-common/recipes-phosphor/host/ampere-hostctrl/ampere-host-on-host-check@.service
@@ -0,0 +1,13 @@
+[Unit]
+Description=Check Host%i status before obmc-host-startmin
+After=obmc-host-started@%i.target
+After=obmc-power-start-pre@%i.target
+Conflicts=obmc-host-stop@%i.target
+Conflicts=phosphor-reset-host-check@%i.service
+OnFailure=obmc-host-quiesce@%i.target
+OnFailureJobMode=flush
+ConditionPathExists=!/run/openbmc/host@%i-on
+
+[Service]
+Type=oneshot
+ExecStart=/usr/sbin/ampere_host_check.sh