| #!/bin/sh |
| # For each AVSBus attached power rail set the default boot voltage and then |
| # program the OPERATION register to switch to AVSBus mode and update default |
| # start voltage to what was last programmed in VOUT_COMMAND. This should be run |
| # before power-on. This is platform specific settings that must be |
| # updated/removed if not Swift. |
| |
| i2cset -y 9 0x70 0x00 0x00 b # VDD 0 - PAGE set |
| i2cset -y 9 0x70 0x01 0xB0 b # VDD 0 |
| i2cset -y 9 0x71 0x00 0x01 b # VCS 0 - PAGE set |
| i2cset -y 9 0x71 0x01 0xB0 b # VCS 0 |
| i2cset -y 9 0x71 0x00 0x00 b # VDN 0 - PAGE set |
| i2cset -y 9 0x71 0x01 0xB0 b # VDN 0 |
| |
| i2cset -y 10 0x70 0x00 0x00 b # VDD 1 - PAGE set |
| i2cset -y 10 0x70 0x01 0xB0 b # VDD 1 |
| i2cset -y 10 0x71 0x00 0x01 b # VCS 1 - PAGE set |
| i2cset -y 10 0x71 0x01 0xB0 b # VCS 1 |
| i2cset -y 10 0x71 0x00 0x00 b # VDN 1 - PAGE set |
| i2cset -y 10 0x71 0x01 0xB0 b # VDN 1 |