| #@TYPE: Machine |
| #@NAME: RaspberryPi 3 Development Board |
| #@DESCRIPTION: Machine configuration for the RaspberryPi 3 in 64 bits mode |
| |
| MACHINEOVERRIDES = "raspberrypi3:${MACHINE}" |
| |
| MACHINE_EXTRA_RRECOMMENDS += "\ |
| linux-firmware-rpidistro-bcm43430 \ |
| linux-firmware-rpidistro-bcm43455 \ |
| bluez-firmware-rpidistro-bcm43430a1-hcd \ |
| bluez-firmware-rpidistro-bcm4345c0-hcd \ |
| " |
| |
| require conf/machine/include/tune-cortexa53.inc |
| include conf/machine/include/rpi-base.inc |
| |
| RPI_KERNEL_DEVICETREE = " \ |
| broadcom/bcm2710-rpi-3-b.dtb \ |
| broadcom/bcm2710-rpi-3-b-plus.dtb \ |
| broadcom/bcm2837-rpi-3-b.dtb \ |
| " |
| |
| SERIAL_CONSOLES ?= "115200;ttyS0" |
| |
| UBOOT_MACHINE = "rpi_3_config" |
| MACHINE_FEATURES_append = " vc4graphics" |
| |
| # When u-boot is enabled we need to use the "Image" format and the "booti" |
| # command to load the kernel |
| KERNEL_IMAGETYPE_UBOOT ?= "Image" |
| # "zImage" not supported on arm64 and ".gz" images not supported by bootloader yet |
| KERNEL_IMAGETYPE_DIRECT ?= "Image" |
| KERNEL_BOOTCMD ?= "booti" |
| |
| ARMSTUB ?= "armstub8.bin" |