linux-aspeed: Move to 4.19
The OpenBMC ASPEED kernel continues in it's quest to track upstream.
This tree is a rebase of the dev-4.18 tree on top of 4.19 witht 58 out
of tree patches.
Currently the base is 4.19.6, the latest 4.19 stable release.
The out of tree patches are as follows. Note that some of these have
landed in 4.20 or are queued for 4.21.
Adriana Kobylak (1):
ARM: config: aspeed: Add Network Block Device
Alexander Amelkin (1):
mtd: spi-nor: fix options for mx66l51235f
Andrew Jeffery (8):
ARM: dts: aspeed: witherspoon: Update max31785 node
dt-bindings: hwmon: pmbus: Add Maxim MAX31785 documentation
pmbus (max31785): Add support for devicetree configuration
pmbus (core): One-shot retries for failure to set page
pmbus (core): Use driver callbacks in pmbus_get_fan_rate()
pmbus (max31785): Wrap all I2C accessors in one-shot failure handlers
soc: aspeed: Miscellaneous control interfaces
ARM: dts: aspeed-g5: Expose VGA and SuperIO scratch registers
Benjamin Herrenschmidt (4):
ARM: dts: aspeed: Romulus system can use coprocessor for FSI
ARM: dts: aspeed: Palmetto system can use coprocessor for FSI
ARM: dts: aspeed: Add Power8 CFAM description for use by Palmetto
ARM: dts: aspeed: Add Power9 CFAM description
Brad Bishop (1):
ARM: configs: Remove atags from Aspeed G4 config
Brendan Higgins (1):
i2c: aspeed: fix invalid clock parameters for very large divisors
Christopher Bostic (1):
iio: dps310: Temperature measurement errata
Cyril Bur (1):
misc: Add ASPEED mbox driver
Cédric Le Goater (7):
mtd: spi-nor: aspeed: use command mode for reads
mtd: spi-nor: aspeed: add support for SPI dual IO read mode
mtd: spi-nor: aspeed: link controller with the ahb clock
mtd: spi-nor: aspeed: optimize read mode
mtd: spi-nor: aspeed: limit the maximum SPI frequency
ARM: dts: aspeed: Add "spi-max-frequency" property
/dev/mem: add a devmem kernel parameter to activate the device
Eddie James (1):
fsi: sbefifo: Add missing mutex_unlock
Edward A. James (2):
drivers/fsi: Add On-Chip Controller (OCC) driver
hwmon: Add On-Chip Controller (OCC) hwmon driver
Guenter Roeck (1):
i2c: aspeed: Acknowledge most interrupts early in interrupt handler
Jae Hyun Yoo (1):
i2c: aspeed: Handle master/slave combined irq events properly
Joel Stanley (19):
ARM: dts: aspeed-palmetto: Add LPC control node
ARM: dts: aspeed-palmetto: Add i2c OCC hwmon node
ARM: dts: aspeed-ast2500: Update flash layout
ARM: dts: aspeed: Add LPC mailbox node
ARM: dts: aspeed: Enable mbox
iio: Add driver for Infineon DPS310
ARM: dts: aspeed-g4: Expose SuperIO scratch registers
ARM: dts: aspeed-g5: Add resets and clocks to GFX node
ARM: dts: aspeed: Enable the GFX IP
ARM: dts: aspeed: Enable VHUB on Romulus
drm: Add ASPEED GFX driver
drm: aspeed: Debugfs interface for GFX registers
dt-bindings: gpu: Add ASPEED GFX bindings document
ARM: config: aspeed: Add out of tree drivers
ARM: dts: Add OCC description to Power9 dtsi
rtc: Add ASPEED RTC driver
dt-bindings: rtc: Add ASPEED description
ARM: aspeed: Add RTC node
ARM: config: aspeed: Add internal RTC driver
Justin.Lee1@Dell.com (1):
net/ncsi: Extend NC-SI Netlink interface to allow user space to send NC-SI command
Lei YU (1):
ARM: dts: aspeed: romulus: Enable iio-hwmon-battery
Matt Spinler (1):
ARM: dts: aspeed: wspoon: Enable iio-hwmon battery
Tomer Maimon (2):
dt-binding: pinctrl: Add NPCM7xx pinctrl and GPIO documentation
pinctrl: nuvoton: add NPCM7xx pinctrl and GPIO driver
Vijay Khemka (2):
net/ncsi: Add NCSI OEM command support
net/ncsi: Add NCSI Broadcom OEM command
Wolfram Sang (1):
i2c: aspeed: use proper annotation for "fall through"
YueHaibing (1):
net/ncsi: remove duplicated include from ncsi-netlink.c
Change-Id: Ia45aa6c3fcd7edb3face492f3ff4586fa2ff5418
Signed-off-by: Joel Stanley <joel@jms.id.au>
1 file changed