| This README file contains information on the contents of the |
| {{=layer_name}} layer. |
| |
| Please see the corresponding sections below for details. |
| |
| |
| Dependencies |
| ============ |
| |
| This layer depends on: |
| |
| URI: git://git.openembedded.org/bitbake |
| branch: master |
| |
| URI: git://git.openembedded.org/openembedded-core |
| layers: meta |
| branch: master |
| |
| URI: git://git.yoctoproject.org/xxxx |
| layers: xxxx |
| branch: master |
| |
| |
| Patches |
| ======= |
| |
| Please submit any patches against the {{=layer_name}} layer to the |
| xxxx mailing list (xxxx@zzzz.org) and cc: the maintainer: |
| |
| Maintainer: XXX YYYYYY <xxx.yyyyyy@zzzzz.com> |
| |
| |
| Table of Contents |
| ================= |
| |
| I. Adding the {{=layer_name}} layer to your build |
| II. Misc |
| |
| |
| I. Adding the {{=layer_name}} layer to your build |
| ================================================= |
| |
| --- replace with specific instructions for the {{=layer_name}} layer --- |
| |
| In order to use this layer, you need to make the build system aware of |
| it. |
| |
| Assuming the {{=layer_name}} layer exists at the top-level of your |
| yocto build tree, you can add it to the build system by adding the |
| location of the {{=layer_name}} layer to bblayers.conf, along with any |
| other layers needed. e.g.: |
| |
| BBLAYERS ?= " \ |
| /path/to/yocto/meta \ |
| /path/to/yocto/meta-yocto \ |
| /path/to/yocto/meta-yocto-bsp \ |
| /path/to/yocto/meta-{{=layer_name}} \ |
| " |
| |
| |
| II. Misc |
| ======== |
| |
| --- replace with specific information about the {{=layer_name}} layer --- |