| # Introduction |
| |
| Swampd's primary function is to drive the fans of a system given various inputs. |
| |
| # Layout |
| |
| The code is broken out into modules as follows: |
| |
| * `dbus` - Any read or write interface that uses dbus primarily. |
| * `experiments` - Small execution paths that allow for fan examination |
| including how quickly fans respond to changes. |
| * `ipmi` - Manual control for any zone is handled by receiving an IPMI message. |
| This holds the ipmid provider for receiving those messages and sending them |
| onto swampd. |
| * `notimpl` - These are read-only and write-only interface implementations that |
| can be dropped into a pluggable sensor to make it complete. |
| * `pid` - This contains all the PID associated code, including the zone |
| defintion, controller definition, and the PID computational code. |
| * `scripts` - This contains the scripts that convert YAML into C++. |
| * `sensors` - This contains a couple of sensor types including the pluggable |
| sensor's definition. It also holds the sensor manager. |
| * `sysfs` - This contains code that reads from or writes to sysfs. |
| * `threads` - Most of swampd's threads run in this method where there's just a |
| dbus bus that we manage. |
| |
| |
| # Design |
| |
| One defines a series of sensors and a series of PIDs that utilize those sensors |
| as inputs (and outputs). |
| |
| The thermal PID |
| |
| set-point -------->|---|---> RPM |
| current value ---->|___| |
| |
| The fan PID |
| |
| set-point -------->|---|---> pwm% |
| current value ---->|___| |
| |
| How to get set-point for fan PIDs |
| |
| thermal-out ----->|-----| |
| thermal-out ----->| |-----> RPM |
| thermal-out ----->| MAX | |
| thermal-out ----->|_____| |