| # The Serial Flash Controller is the AST2400 BMC. |
| set SFC_IS_AST2400 |
| set PNORDD_IS_IPMI |
| unset PNORDD_IS_SFC |
| set BMC_DOES_SFC_INIT |
| unset SFC_IS_IBM_DPSS |
| set ALLOW_MICRON_PNOR |
| set ALLOW_MACRONIX_PNOR |
| |
| # VPD options. |
| set MVPD_READ_FROM_HW |
| set MVPD_WRITE_TO_HW |
| set MVPD_READ_FROM_PNOR |
| set MVPD_WRITE_TO_PNOR |
| set DJVPD_READ_FROM_HW |
| unset DJVPD_WRITE_TO_HW |
| set DJVPD_READ_FROM_PNOR |
| set DJVPD_WRITE_TO_PNOR |
| set CVPD_READ_FROM_HW |
| set CVPD_WRITE_TO_HW |
| set CVPD_READ_FROM_PNOR |
| set CVPD_WRITE_TO_PNOR |
| set PVPD_READ_FROM_HW |
| set PVPD_WRITE_TO_HW |
| set PVPD_READ_FROM_PNOR |
| set PVPD_WRITE_TO_PNOR |
| set SKIP_RESTRICT_EX_UNITS |
| unset CDIMM_FORMAT_FOR_CVPD |
| |
| # gpio config |
| set GPIODD |
| set PALMETTO_VDDR |
| |
| # Enable SBE updates |
| #set SBE_UPDATE_INDEPENDENT |
| set SBE_UPDATE_SIMULTANEOUS |
| |
| unset PCIE_HOTPLUG_CONTROLLER |
| |
| # turn on console output |
| set CONSOLE |
| set BMC_AST2400 |
| |
| # Enable Kingston dimm voltage workaround |
| unset KINGSTON_1_35_VOLT |
| |
| unset DISABLE_HOSTBOOT_RUNTIME |
| |
| # Compile in hostboot runtime PRD |
| set HBRT_PRD |
| set HTMGT |
| set START_OCC_DURING_BOOT |
| |
| #PNOR flags |
| unset PNOR_TWO_SIDE_SUPPORT |
| set PNOR_IS_32MB |
| |
| set BMC_BT_LPC_IPMI |
| |
| unset SET_NOMINAL_PSTATE |
| |
| # Enable Checktop Analysis |
| set ENABLE_CHECKSTOP_ANALYSIS |
| set IPLTIME_CHECKSTOP_ANALYSIS |
| |
| # Hostboot will detect hardware changes |
| set HOST_HCDB_SUPPORT |
| |
| # set for trace debug to console |
| unset CONSOLE_OUTPUT_TRACE |