| # The HIOMAP protocol is used to access PNOR |
| unset SFC_IS_AST2500 |
| unset SFC_IS_AST2400 |
| set PNORDD_IS_IPMI |
| unset PNORDD_IS_SFC |
| set ALLOW_MICRON_PNOR |
| set ALLOW_MACRONIX_PNOR |
| |
| # VPD options - Enable EECACHE |
| set MVPD_READ_FROM_HW |
| set MVPD_WRITE_TO_HW |
| unset MVPD_READ_FROM_PNOR |
| unset MVPD_WRITE_TO_PNOR |
| |
| set DJVPD_READ_FROM_HW |
| set DJVPD_WRITE_TO_HW |
| unset DJVPD_READ_FROM_PNOR |
| unset DJVPD_WRITE_TO_PNOR |
| |
| set MEMVPD_READ_FROM_HW |
| set MEMVPD_WRITE_TO_HW |
| unset MEMVPD_READ_FROM_PNOR |
| unset MEMVPD_WRITE_TO_PNOR |
| |
| #set PVPD_READ_FROM_HW |
| #set PVPD_WRITE_TO_HW |
| #unset PVPD_READ_FROM_PNOR |
| #unset PVPD_WRITE_TO_PNOR |
| |
| unset CDIMM_FORMAT_FOR_CVPD |
| |
| # gpio config |
| set GPIODD |
| unset PALMETTO_VDDR |
| |
| # Enable Consecutive SBE Updates |
| unset SBE_UPDATE_CONSECUTIVE |
| unset SBE_UPDATE_INDEPENDENT |
| unset SBE_UPDATE_SEQUENTIAL |
| unset SBE_UPDATE_SIMULTANEOUS |
| set NO_SBE_UPDATES |
| |
| #unset PCIE_HOTPLUG_CONTROLLER |
| |
| # turn on console output |
| set CONSOLE |
| set BMC_AST2500 |
| |
| #set DISABLE_HOSTBOOT_RUNTIME |
| |
| # Compile in hostboot runtime PRD |
| #unset HBRT_PRD |
| |
| # Compile in hb rt HTMGT : Load/Start OCC |
| #unset HTMGT |
| #unset START_OCC_DURING_BOOT |
| #unset CONSOLE_OUTPUT_OCC_COMM |
| |
| # PNOR flags |
| unset PNOR_TWO_SIDE_SUPPORT |
| |
| set BMC_BT_LPC_IPMI |
| set AXONE |
| set AXONE_BRINGUP |
| set SUPPORT_EEPROM_CACHING |
| |
| # Enable Checkstop Analysis for both |
| # Runtime and IPLtime scenarios |
| unset IPLTIME_CHECKSTOP_ANALYSIS |
| |
| # set for trace debug to console |
| set CONSOLE_OUTPUT_TRACE |
| #set CONSOLE_OUTPUT_FFDCDISPLAY |
| |
| # Terminate Hostboot when errors occur in manufacturing mode |
| # (relies on BMC to not trigger reboot) |
| #unset HANG_ON_MFG_SRC_TERM |
| |
| # This is not working in P10 op-build |
| unset ENABLE_HDAT_IN_HOSTBOOT |